Managing carbon dioxide to optimise hatchability

The hatchery was using several generations of incubators, from very old to relatively new machines. Hatchabilities had not been assigned to machine type, which complicated my investigation. However one common issue was that all the setters at end of the cycle were unable to achieve unrealistically high humidity set points. This was partially due to very dry inlet air, which forced the setters’ humidifiers to work constantly and created cold spots that extended the hatch window.

On day two of my visit there was a hatch. While I was very pleased with the chick quality, a breakout of unhatched eggs from various machines revealed too many embryos dying just before internal pipping.  Air cells were large enough and the embryos had a normal, dry appearance, so this was not due to insufficient weight loss. What then was the cause? 

Studying climate graphs from recent hatcher cycles revealed that although the newest hatchers were equipped with CO₂ sensors, these were not being used to automatically control the fresh air supply. Instead, these modern hatchers were being managed traditionally, using stepped increases in set point to position the air valve. The CO₂ line in the climate graph showed much higher values than recommended, ranging from 0.8% right after transfer to over 1% - and at times, even higher values than the sensor could measure (> 1.3 %). When I shared these findings with the hatchery manager, we agreed that these high CO₂ levels were the most likely cause of late embryo mortality and I suggested two remedial options - either:

1. Fine-tune valve set points on measured CO₂ values: aim for 0.5% immediately after transfer, to a maximum of 0.8% at the onset of hatch and reducing again when the hatch is complete. For older hatchers without CO₂ sensors, my advice was to increase valve positions to create a similar profile from transfer to the completion of hatch.
2. As an alternative, I advised using CO₂ set points to automatically control valve positions.

The hatchery manager chose the first option, which felt more familiar to him. But some months later, he called to tell me that my second suggestion, using automatic valve control in the newest hatchers, was much easier and more importantly hatchability was now consistently “very good”.